Key Word: Taili Plastic Machinery; Taili Plastic Machinery-Capacity Improving Expert; Efficient; Stable; Low Pressure and High Speed
Because of the short cycle time and high injection speed, high-speed injection molding machine is specially used for manufacturing thin-walled plastic products such as disposable packaging food containers.
Some high-speed injection molding machine for thin-wall products may not be expensive. However, due to immature technology, the later maintenance cost is very high. In particular, the time wasted and the cost spent in maintenance greatly increase the cost of manufacturers.
Recently, Mr. Li from Guangdong came to Taili Plastic Machinery and said that he had been in this industry for about three years, and he has purchased about 16 sets of injection molding machine. However, he feels it more and more difficult in doing the business. Recently, the pull rod of one of his equipment, which has been purchased for about one year, has broken down. They waited for the manufacturer of the injection molding machine for a long time but they has not come to repair it. Finally, after the pull rod was replaced, the original products could not be produced. Even if the mold locking pressure and injection pressure were increased, it would not make any effect.
In view of this problem, we asked Mr Li whether he checked the following three aspects when had received the machine a year ago:
1. Is the temperature of mold runner consistent before the machine leaves the factory?
2. Whether the injection temperature is 315 ¡æ?
3. In the whole production process, whether the injection pressure and mold locking pressure exceed 120 bar?
Only with low pressure high speed, the injection molding machine for thin-wall product will have long service life, otherwise it is extremely prone to failure.
Mr. Li replied: ¡°at that time, I didn't check the machine carefully. I believed there would be no problem as the product was produced.¡± Taili Plastic Machinery would like to recommend you here attention must be paid to the three problems mentioned before hen testing the machine. Only with low pressure and high speed can the machine be called high-speed injection molding machine for thin-wall product!
Taili Plastic Machinery always keeps in mind that what a good injection molding machine factory should do is to help improving the capacity and boosting the profits, rather than offer the similar products the customers need. This is also what Taili Plastic Machinery keeps doing.
Follow Taili Plastic Machinery and we will share more with you.
|
